Monday, April 07, 2008

DIY : Guitar Pick Holder

This is a simple DIY guitar pick holder, inspired like the ones in concerts; where they place extra picks along the microphone stand boom for easy reach. Well, I don't perform in gigs nor concerts, but I just like how the picks lined up nicely and how easy it is to access them.

This is a relatively easy project and would only take 10 to 15 minutes. To make the holder, you would require the following items :

Intro : Materials for the pick holder
~ 1 Binder Bar ~ 1 A4 size Foam Board

~ Steel ruler ~ cutter
~ magic tape ~ 3mm diameter rod

Step 1

Cut the foam board to a 3 cm strip

Step 2

Fold the foam strip into two along its length and tape it to a steel ruler. Fold in way to have one side is slightly wider than the other.

Step 3

Insert the foam board into the binder bar by sliding it in with the ruler from one side till its fully in.

Step 4

Remove the taping and peel off the ruler.

Step 5

Trim off the access foam at both end, and there you have it; a concert like guitar pick holder.

Should you need a more detailed step-by-step guide, view my entry at for more info. Hope you find this entry useful and easy enough to follow.


Anonymous said...

woof woof!

Lenny said...

wah wah...

bagus nieh... nanti mesti alya suka... buat main2..

daddy dier dah pencen main gitar.. beria dulu menuntut ilmu ngan u kan..
tah ingat lg ke tak tah skang nieh..

kL said...


kL said...

ahahaa.. ingat lagi kot.. :)