DIY : Guitar Pick Holder

This is a simple DIY guitar pick holder, inspired like the ones in concerts; where they place extra picks along the microphone stand boom for easy reach. Well, I don't perform in gigs nor concerts, but I just like how the picks lined up nicely and how easy it is to access them.

This is a relatively easy project and would only take 10 to 15 minutes. To make the holder, you would require the following items :

Intro : Materials for the pick holder
~ 1 Binder Bar ~ 1 A4 size Foam Board

Tools
~ Steel ruler ~ cutter
~ magic tape ~ 3mm diameter rod


Step 1

Cut the foam board to a 3 cm strip





Step 2

Fold the foam strip into two along its length and tape it to a steel ruler. Fold in way to have one side is slightly wider than the other.



Step 3

Insert the foam board into the binder bar by sliding it in with the ruler from one side till its fully in.




Step 4

Remove the taping and peel off the ruler.





Step 5

Trim off the access foam at both end, and there you have it; a concert like guitar pick holder.

Should you need a more detailed step-by-step guide, view my entry at Instructables.com for more info. Hope you find this entry useful and easy enough to follow.